September 2026 - District XI

District News

Alaska, Idaho, Montana, Oregon, Washington

Hi all. I can’t believe it’s that time again. I’m so much busier than I was when I was "working."

We had a jet event at Weaver’s Airfield in Othello, Washington, called the Weaver’s Jet Stampede. It was a great success. You always wonder when you start something new if it is going to go or not; this one did great. There were more than 20 pilots, a big bunch of jets, and a lot of flying going on! Everyone said, "Let’s do it again!" I’m pretty sure we will. Here are a few pictures.

Image
Model planes with various designs lined up on grass at an airfield.
Image
Model aircraft displayed on a field with people standing behind them.
Image
Workshop filled with colorful model airplanes and scattered chairs.

 

I traveled to AMA Headquarters in Muncie, Indiana, as well. I have always wanted to visit with my bigger toys. Here is a picture in front of the National Model Aviation Museum when I pulled in.

Image
Large RV with attached trailer parked on a road near a building and tree.

There is an amazing amount of modeling here. The museum is fantastic and the flying sites are amazing. It’s a must-see for us all.

I want to give a shoutout to AMA’s maintenance crew; they work very hard to have the grounds in great condition. Here is a picture of a couple of them moving a tent, which was interesting to watch.

Image
Golf cart towing a large blue and white tent on a trailer on a paved road.

The AMA National Fun Fly was also held at the International Aeromodeling Center. There were some weather challenges, but there was still a good turnout, and a lot of fun was had. The AMA Foundation was in charge of lunch, and they did a great job.

Image
Outdoor BBQ setup with people preparing food under a striped tent.

Andrew Griffith, my counterpart from District V, even took a turn flying one of my jets!

Image
Man with a remote control and a red, white, and blue model plane on a tarmac.

That’s all for this month. I have more adventures planned. I’ll fill you in as I go.

Phil Tallman

Vice President

[email protected]